Pool Filter Problems

If you are having problems with your pool filter passing dirt and don't know where to start, this record is meant to help you diagnose the problem correctly. The filter referred to is a de filter but can be applied to sand and cartridge.

Many citizen don't know where to begin when trying to find the think their filter is passing dirt back into the pool. The first thing that needs to be done is for the backwash valve to be inspected. This is rarely the cause of dirt returning to the pool but is the easiest step in looking for the problem. If it is a push pull valve the plunger needs to be removed. If need be a diagram should be referred to, loosen the nut or nuts and pull the shaft up out of the housing. contemplate the two O rings pay singular concentration to the top O ring. The top ring causes the dirt to return to the pool. When there is a problem with the lowest ring the backwash will leak water out the drain. This causes the pool to loose water. When checking the O rings look for wear, nicks or cracks. If you find the top O ring to be the problem then replace and lube with a silicone type grease. If a petroleum lube is used the rubber rings will swell. Tip, replace both O rings to preclude any other problems from occurring.

Solve A Fraction Problem

If the backwash valve is not the problem then the filter itself should be dismantled. First contemplate the manifold, this is the plastic unit that the grids are placed. Look for any cracks or the many itself being distorted. This can be caused from inordinate heat, when the many becomes distorted the shape of it changes and it is very easy for dirt to pass. If the many seems Ok then clean and contemplate the grids. One of the most common spots to wear is the top of the grid. A tube runs straight through the middle of the grid and at the top it forms a circle. Many times a small hole will be present. This can be the cause of the dirt passing into the pool. If there are not any holes in the top of the grids then contemplate the rest of the exterior of the grids. Look for holes or rips, if found replace the grid.

In closing taking this task one step at a time will help lead to a flourishing job. Check the backwash valve then contemplate the many and grids. This should solve any problems that you are having with the pool filter.

Pool Filter Problems